Havis-shields C-VS-1200-F250-1 User Manual download pdf

INSTALL INSTRUCTIONS C-VS-1200-F250-1

Vehicle Specific Console

2008 FORD F-250, 350, 450 and 550 Pickup and Cab Chassis Trucks

TOOLS REQUIRED:

Ratcheting wrench Phillips Screwdriver

Metric/Standard Socket Set T-20 Torx Driver bit

7/16” Wrench 7 mm Socket or Driver

INSTALLATION HARDWARE:

QTY DESCRIPTION PART #

1 ¼” X 1” Hex Bolt GSM33002B

5 ¼” X ½” Carriage Bolt GSM31999

6 ¼” Serrated Hex Flange Nut GSM30023

1 ¼” Flat Washer GSM31005B

3 #8 x ¼” Flat Head Phillips Screw GSM33178

1 Torx Screw Kit C-HK-1

All other hardware is pre assembled on console or OEM hardware is reused.

Always

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use only hardware provided with install kit.

 For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html, email [email protected] or call

1-800-524-9900 and ask for technical support.

***Crew Cab trucks will require the removal of the air conditioning / heat duct

that runs on top of the transmission hump to rear seats. Installer will need to

block off remaining duct opening. Screws, foam and duct tape can be used to

close off duct. (Not included)***

1 2 3 4

4 INSTALL INSTRUCTIONS C-VS-1200-F250-1 Vehicle Specific Console 2008 FORD F-250, 350, 450 and 550 Pickup and Cab Chassis Trucks TOOLS REQUIRED: R

C-VS-1200-F250-1_INST_2-08 2 OEM Dashboard Carefully remove the small dash panel that holds the lighter plug. Use 7mm socket and remove dash mount

Page 3

C-VS-1200-F250-1_INST_2-08 3 Assemble the two-piece dash adaptor panel with three (3) #8 x ¼” Flat Head sheet metal screws. Use 7mm socket and remove

Page 4

C-VS-1200-F250-1_INST_2-08 4 Wire and mount all control heads. Note: Installation of lower faceplate screws may require a T-20 Torx bit in a ratchet

No comments

Havis-shields C-VS-1200-F250-1 User Manual