Havis-shields 2006-2007 Dodge Charger and Magnum C-VS-2400-CHGR User Manual download pdf

INSTALL INSTRUCTIONS

C-VS-2400-CHGR & C-VS-2400-CHGR-1

2006 – 2007 DODGE CHARGER and MAGNUM

2008 DODGE CHARGER and MAGNUM

TOOLS REQUIRED:

Ratcheting wrench

Sockets - 7/16”, 10mm, 8mm

Screwdriver set

T-20 Torx bit

HARDWARE:

ITEM QTY DESCRIPTION PART#

1 1 Console housing assembly C-VS-2400-CHGR-H

2 1 Front support bracket CM001593

3 2 Side trim panels - 2006 – 2007 Charger CM001598-D and P

3 2 Side trim panels - 2008 Charger CM002164 and CM002165

4 1 Front floor bracket CM001595

5 1 Sensor guard CM001638

6 1 Rear floor panel CM001642

7 6 #10 x ½” machine screws GSM33118

8 2 #10 keps nuts GSM30028

9 4 #10 flat washers GSM31003

10 4 ¼” flat washer GSM31005

11 4 ¼” x ½” carriage bolt GSM31999

12 4 ¼” Nylock nut GSM30016

2 ¼” x ¾” self threading bolt GSM33060-1

2 ¼” x 1” fender washer GSM31014

2 6mm hex nut GSM30201

1 1-1/16” diameter plug GSM20017-1

1 Hardware Kit C-HK

1 Torx Hardware Kit C-HK-1

10, 11, 12 7, 9

7, 9

5 - Not shown, approximate location

1 2 3

INSTALL INSTRUCTIONS C-VS-2400-CHGR & C-VS-2400-CHGR-1 2006 – 2007 DODGE CHARGER and MAGNUM 2008 DODGE CHARGER and MAGNUM TOOLS REQUIRED: Ratche

C-VS-2400-CHGR_INST_12-07 2 Always!  Read all instructions before installing any Havis-Shields Equipment Corp products.  Check for obstructions (Wi

C-VS-2400-CHGR_INST_12-07 3 Position sensor guard to align with OEM floor nut serts (Item 5) Position rear-floor panel, continue to align with OEM

No comments

Havis-shields 2006-2007 Dodge Charger and Magnum C-VS-2400-CHGR User Manual